Stephen Carroll, a freelance photographer from Reston, Virginia, specializes in artwork for book covers, with more than 400 (mostly novels) to his credit. They’re not just any book covers, though. His genius lies in creating film noir-like scenes, complete with desperate lovers, soaked T-shirts, smoking […]
Canon sensor cleaning: remove dust in 4 steps
our Canon DSLR is a picture-taking tool that’s been designed to capture tens of thousands of photos without any problems – and your lenses should provide a lifetime of service, too. But, like all tools, it needs to be looked after properly if it’s to keep running smoothly. By far your biggest concern will be dust, and the tutorial below will show you a simple Canon sensor cleaning technique to keep your EOS camera running smoothly.
We all know that when you change lenses, dust can enter the camera and be deposited on the filter in front of the sensor. Dust can even be generated inside the camera by the friction between moving parts.
Whatever the cause, the result is the same: blotches in the same place on every frame. When you consider that the imaging sensor inside your Canon DSLR is packed with millions of receptors, yet isn’t much bigger than a postage stamp, you can imagine how much detail a minute piece of dust can potentially obscure in an image.
Sensor dust is most noticeable in areas of smooth, pale tones such as skies, particularly if you’re shooting with narrow apertures, and it becomes particularly obvious if you use a narrow aperture and slow shutter speed during a panning shot.
Bear in mind that it’s only once you’ve taken a picture and you’re looking at it on the rear LCD or on a computer that you’ll spot sensor dust. If you notice other specks when you’re looking through the viewfinder, it’s either the viewfinder window or the mirror inside the camera that require a quick blast from a rubber bulb blower.
The Integrated Cleaning System inside your Canon DSLR does a fine job of vibrating most of the offending particles away from the sensor, but it isn’t perfect. Image-editing programs such as Photoshop make removing any shake-resistant spots relatively simple, but it’s better to remove the dust from the sensor directly.
If you’ve got the right tools and lots of patience you can have a go yourself; although bear in mind that you’ll void your warranty, and replacing a scratched sensor doesn’t come cheap! If in any doubt, leave it to a Canon-approved service centre.
What you’ll need to clean the sensor in your EOS camera
A whole industry has built up around camera care products, with sensor cleaning devices in particular taking many different formats. But which items do you really need?
We’d recommend that a minimum on-the- road cleaning kit comprises a bulb blower, brush and microfibre cloth. You can add a set of wet/dry sensor swabs and a sensor loupe if you’re confident of removing dust manually, although with the EOS Integrated Cleaning System doing a genuinely fine job of removing dust particles automatically, this should be a relatively rare requirement.
It’s also a good idea to keep a pack of lint-free Pec-Pads or lens tissues in your camera bag to help remove marks from lens mounts, buttons and LCD screens.
Warning: dust-spotting your Canon camera’s sensor requires a gentle touch and the right equipment.
How to clean the sensor in your EOS camera
Step 1: Try auto cleaning
Make sure the camera battery is fully charged, then select the ‘Sensor cleaning’ option in the second Setup (yellow) menu. Choose the automatic option to start with.
Step 2: Switch to manual
If dust persists, return to the sensor cleaning menu and select the manual option. This locks the mirror up and opens the shutter. Remove the lens to get access to the sensor.
Step 3: Use a blower
First, use a manual air blower to dislodge any particles – face the camera down so that these fall out of the body. Avoid using a compressed air can. Now take a test shot.
Step 4: Start dry cleaning
If dust remains, charge a sensor brush for ten seconds and carefully drag this over the sensor. If dirt is stuck to the sensor, do a wet clean with a swab and sensor cleaning fluid.
When the sensor has been cleaned – either automatically by the camera or manually, by you – take a test shot to check that all is clear. Switch the camera to Av mode, and set the smallest aperture available on the lens.
Photograph a bright, clean area – a piece of white paper is ideal – with the lens manually focused at a close distance. Upload this shot to your imaging software and apply Auto Levels or the equivalent to show up any specks.
The bottom of the image actually represents the top of the sensor, so flip the image vertically prior to cleaning your sensor to find out where on the sensor the dust lies. A sensor loupe – a device incorporating a magnifying lens and lights that fits over the lens mount – is also a great aid here.
Spring is the time when Mother Nature hits back and the greys of winter give way to lush greens and vivid colour as plants and trees burst into life. But it’s not just the fauna and flora that come out of hibernation. The longer days […]
Adding contrast to a landscape photo is one way to make it a more compelling image. When we think of the word “contrast” we usually think about contrasting colors or brightness. But, there’s also another type of contrast that you can capture in your images: […]
Taking amazing photos is something many aspiring amateur photographers strive for. And HDR effects can really make your images pop. Below is a complete toolbox to get you started with HDR photography on your own. Whether you want to go all out and learn how […]
After many years as a keen amateur photographer, I decided to start a small landscape photography business called Lakescenes which I ran alongside my main job as an IT Manager. As business increased, I found myself working long, but rewarding, hours just to keep up […]
Rob Sheppard is a naturalist, nature photographer and videographer who says his favorite location is the one he is in at any time. He is the author/photographer of over 40 books, as well as a well-known speaker and workshop leader, and a Fellow with the […]
Gary Hart has photographed California’s natural beauty for over 30 years. Gary’s photos and writing have appeared in many publications, most recently Outdoor Photographer and Sierra Heritage magazines. You’ll also find his images in greeting cards, postcards, calendars, and many galleries and private collections throughout the world.
Originally from Poland, based in London UK, Jaroslav has background in Fine Arts, degree in Architecture, and wide array of experience. Being an Architect taught him how to be resourceful and to solve complex problems with simple, yet innovative solutions. Constant passion for graphic & […]
Tom Mangelsen has photographed wildlife from hummingbirds to elephants, but he has a special soft spot for bears. And he’s particularly fond of the grizzlies that roam Grand Teton National Park near his home in Jackson Hole, Wyoming. “The more I see bears, the more […]
I’m in a mild state of shock today. I’ve recently read Watching the English by Kate Fox and discovered things about myself that I was better off not knowing. If you’ve not read the book it can be neatly summarised by the following: in terms […]